Filter
Top Products
Sending Internet E-Mail (SMTP)
Appendix AT Commands MIM-A01
Mitsubishi Industrial Modem 8-17
AT+T Send="Email;..."
AT+T Send="Email; To: Recipient; Dial: Number;From: Sender; Flags:flag
PPPUser: User; PPPPassword: Password; SMTPMailServer: SMTPServer"
>Subject
>MessageText line#1
>MessageText line#n
><CTRL>+<Z>
This command sends an Internet e-mail or sets the parameters.
After closing the command line using <CR/LF>, your Tixi modem displays a prompt (>) where you
can specify the subject line.
The actual message text is entered in the subsequent lines.
To close this message, press <CTRL>+<Z>.
If you skip the message text, the parameters are saved for later use until replaced by new parameters.
Number:
Dialup number of the Internet service provider.
Enter characters which can be dialled (0-9,*,#, comma) only.
Sender:
Internal e-mail address of the message sender, for example,
paul@example.com.
Thisaddressisusedfor theFrom:fieldoftheoutgoingmessage.
Recipient:
Internet e-mail address of the message recipient, recipient
otto@example.net. This address is used for the To: field of the
outgoing message.
flag:
Enter “PbS“ here if POP-before-SMTP is to be used.
(otherwise you can omit the parameter.)
User:
PPP user name to dial into the Internet service provider.
Password:
PPP password.
SMTPServer:
Nameoraddressof theSMTPserverthatisto sendthemessage,
for example, mail.provider.com.
Subject:
Subject line of the e-mail.
Thisis alwaysgeneratedfromthe firstlinethat isenteredafterthe
prompt.
MessageText line#1...n:
Other lines of the e-mail text.
Each lineis entered atthe prompt characterdisplayed bythe mo-
dem and closed by <ENTER>. The message text must not con-
tain umlauts.
Example:
An Internet e-mail is sent:
AT+T Send="EMail; Dial: 0191011; From: user@example.com;
To: info@example.net;
PPPUser: 00012345678445566; PPPPassword: Rose;
SMTPMailServer: smtp.t-online.de"
>Hello Paul,
>This is the important message sent by e-mail.
><CTRL>+<Z>
Short modem reply:
OK