Filter
Top Products
9 - 21 9 - 21
MELSEC-Q
9 LOADING AND INSTALLATION
(a) To connect an extension cable to the main base unit, remove the portion
under the OUT characters on the base cover with a tool such as a flat-blade
screwdriver (5.5
75, 6 100).
This also applies to a case where an extension cable is connected to the OUT
side connector of the extension base unit.
Base cover
OUT
Main base unit
OUTIN
OUT side of extension
base unit
(b) To connect the extension cable to the next extension base unit, remove the
seal applied under the IN characters on the base cover.
S
eal
OUTIN
IN side of extension
base unit
(c) When plugging the extension cable to any base unit, hold the connector part
of the extension cable.
(d) After fitting the extension cable, always tighten the extension cable connector
fixing screws.
(Tightening torque: 20N
•
cm)