Filter
Top Products
Fiber Driver
®
EM316SW-XY
PN 1288003-001, Rev D2
35
4.3.4 Configuration Context
Enter "configuration" context, as shown below, to configure the system parameters.
The commands in this section are entered at the configuration context prompt. They are applied
with the <CR> or <Enter> key, which is not printable.
4.3.4.1 Restoring Default Parameters
Use the default command to discard changes applied to the module configuration. The
example below illustrates returning the entire module to the original factory defaults. Use the “?”
after the default command or refer to EM316LNXNM-OT documentation for parameters to
reapply only selected default values including individual port settings.
The command below is applied in the main configuration context. The first command line in the
box opens this context from the login context.
fiberdriver(config)# default 1 all
Restored default configuration for 1
Restored default configuration for 1.1
Restored default configuration for 1.1.1
Restored default configuration for 1.1.2
Restored default configuration for 1.1.3
Restored default configuration for 1.1.4
Restored default configuration for 1.2
Restored default configuration for 1.3
Restored default configuration for 1.3.1
Restored default configuration for 1.3.2
Restored default configuration for 1.3.3
Restored default configuration for 1.3.4
Restored default configuration for 1.4
Restored default configuration for 1.5
Restored default configuration for 1.6
Restored default configuration for 1.7
Restored default configuration for 1.8
Restored default configuration for 1.9
Restored default configuration for 1.10
Restored default configuration for 1.11
Restored default configuration for 1.12
Restored default configuration for 1.13
Restored default configuration for 1.14
Restored default configuration for 1.15
Restored default configuration for 1.16
fiberdriver(config)#
fiberdriver# configu
fiberdriver(config)#
re terminal