Filter
Top Products
Fiber Driver
®
EM316SW-XY
PN 1288003-001, Rev D2
53
4.3.7.6 “show config”
The show config command displays the active environment settings currently in the
operational context. The lines beginning with “!” are comments added for clarity in the CLI
display only. The comment lines ending with “:” are headings that describe the settings listed
in this display.
The default parameter values are constant for each module, but can change to reflect DIP
switch settings. Changes to these parameter values are reflected in the show config
command output. Restoring the default values returns the module to its original operating
state. Preserve changes made to the configuration for use in future CLI sessions and beyond
a reboot by writing them to the startup-config file as described later in this section.
4.3.7.7 “shutdown” and “no shutdown”
The shutdown commands enable and disable the transmitter of the target port. SFP ports in
redundant mode may not be disabled, so the command is not available in the corresponding
mode and context.
fiberdriver(port/1.3.1)#
s
hutdown
fiberdriver(port/1.3.1)# no fdrd[60]|TRAP| warn|Jan 01 19:25:25
Port 1.3.1 Disabled, Chassis Name: NC316BU-16 Slot
Name: EM316SW-XY at 1.3 Port Name: RJ-45 at 1.3.1
fiberdriver(port/1.3.1)#
fiberdriver(port/1.3.1)# no shutdown
fiberdriver(port/1.3.1)# fdrd[60]|TRAP| warn|Jan 01 19:25:37
Port 1.3.1 Enabled, Chassis Name: NC316BU-16 Slot Nam
e: EM316SW-XY at 1.3 Port Name: RJ-45 at 1.3.1
fiberdriver(port/1.3.1)#
fiberdriver(port/1.3.1)#
s
how config
port 1.3.1
! Configured parameters that override defaults:
! Configured parameters that match defaults:
! Parameters that will follow defaults:
! auto-negotiation
! duplex full
! speed 100
! no shutdown
! description RJ-45 at 1.3.1
! rm-chassis 0
! rm-slot 0
! rm-port 0
! ! auto-neg-adv 0x0f:
! auto-neg-adv all
! mdi-pinout auto-sense
fiberdriver(port/1.3.1)#