Filter
Top Products
Fiber Driver
®
EM316SW-XY
PN 1288003-001, Rev D2
55
4.3.8 RJ-45 Port Commands
The commands in this section are specific to the RJ-45 Ethernet (copper) ports P1 and P4 on
the EM316SW-XY module.
4.3.8.1 “auto-neg-adv”
This command sets the data rates displayed as options in auto-negotiation.
4.3.8.2 “auto-negotiation”
This command sets auto-negotiation mode on the target port.
fiberdriver(port/1.3.1)# auto-negotiation?
auto-negotiation Enable auto-negotiation
fiberdriver(port/1.3.1)# auto-negotiation ?
<cr>
fiberdriver(port/1.3.1)# auto-negotiation
fdrd[60]|CORE| warn|Jan 01 22:35:34 1.3.1: Auto-adjusted
PortMDIPinoutAdmin -> removed Ok
fdrd[60]|CORE| warn|Jan 01 22:35:34 1.3.1: Auto-adjusted
PortDuplex -> removed Ok
fdrd[60]|CORE| warn|Jan 01 22:35:34 1.3.1: Auto-adjusted
PortSpeed -> removed Ok
fiberdriver(port/1.3.1)#
fiberdriver(port/1.3.1)# auto-neg-adv?
auto-neg-adv Adjust auto-negotiation advertisement
fiberdriver(port/1.3.1)# auto-neg-adv ?
10 Advertise 10Base-T
100 Advertise 100Base-Tx
1000 Advertise 1000Base-T
flow-control Advertise flow control
all Advertise all capabilities
full Advertise full duplex only for all speeds
half Advertise half duplex only for all speeds
hex Advertise using hex format (see MIB descr. for
help)
fiberdriver(port/1.3.1)# auto-neg-adv all
fiberdriver(port/1.3.1)#