Filter
Top Products
Fiber Driver
®
EM316SW-XY
PN 1288003-001, Rev D2
49
4.3.7.2 “list”
The list command displays all the full command options (including applicable command
line arguments) available in the current context.
4.3.7.3 “show”
The show command displays management and system information related to the
EM316LNXNM-OT management module, the hosting chassis, other modules in the chassis,
and ports available within the managed system. The arguments (parameters) following the
show command and the operational context displayed by the system prompt control the
many functions available through this command.
The box below illustrates the show command. The help “?” is applied first, then the command
is used with no arguments in the port context of a copper port in an EM316SW-XY module.
The CLI help for the show command is identical in the port-level context and the slot-level
contexts. Refer to the Slot-Level Commands section for “show?” and “show ?” information.
fiberdriver(port/1.3.1)#
s
how
Port: 1.3.1
Name: RJ-45 at 1.3.1
Protocol: Ethernet
Rate: 10Base-T 10 Mbps
Enable: enable LIN: disable
Link: no Signal Speed: 10 Mbps
MDI Pinout: mdi
Duplex: half MDI Pinout desired: auto Sense
Auto Neg: on
Adv 10Base-T: on
Adv 100Base-Tx: on
Connector: RJ45 Medium: twisted Pair
Rx Activity: off Tx Activity: off
fiberdriver(port/1.3.1)#