MRV Communications EM316SW-XY Switch User Manual


 
Fiber Driver
®
EM316SW-XY
PN 1288003-001, Rev D2
1
2 Module Introduction
The Fiber Driver EM316SW-XY is a highly configurable multi-function module that can perform the
functions of hundreds of less sophisticated devices. The SW-XY can operate in four modes. Each of
these applications is described later in this section.
Repeater
Converter
Redundant Fiber Link
Switch
The SW-XY features two RJ-45 copper Ethernet ports (P1 and P4) and two SFP sockets (P2 and P3).
SFP transceivers are available from MRV to support virtually any standard fiber optic or copper
Ethernet protocol.
2.1 Features
This modular design supports a wide variety of module and port features. Some important features
are listed below.
Copper 10/100Base-TX with full wire-speed capabilities
Maximum packet size of 1916 bytes
Auto-negotiation
Half/full-duplex sensing
MDI/MDIX detection
Fault status propagation (LIN and FEFI) except in switch mode
Management tools for status and module control
Port status through front panel LEDs and module management
Hot-swap support
The LIN, MDI/MDIX, and Loopback features are configurable, and each item is introduced below.