Filter
Top Products
4 AT Commands, S-Registers, & Result Codes
43
MultiModemZBA-V-V92 User Guide
Result Codes
In command mode your modem can send responses called
result codes
to your
computer. Result codes are used by communications programs and can also appear
on your monitor.
Terse Verbose Description
0OK
Command executed
1 CONNECT
Modem connected to line
2 RING
Ring signal detected
3 NO CARRIER
Carrier signal lost or not detected
4 ERROR
Invalid command
5 CONNECT 1200 *
Connected at 1200 bps
6 NO DIALTONE
No dial tone detected
7 BUSY
Busy signal detected
8 NO ANSWER
No answer at remote end
10 CONNECT 2400 *
Connected at 2400 bps
11 CONNECT 4800 *
Connected at 4800 bps
12 CONNECT 9600 *
Connected at 9600 bps
13 CONNECT 14400 *
Connected at 14400 bps
14 CONNECT 19200 *
Connected at 19200 bps
24 CONNECT 7200 *
Connected at 7200 bps
25 CONNECT 12000 *
Connected at 12000 bps
26 CONNECT 16800 *
Connected at 16800 bps
40 CONNECT 300 *
Connected at 300 bps
55 CONNECT 21600 *
Connected at 21600 bps
56 CONNECT 24000 *
Connected at 24000 bps
57 CONNECT 26400 *
Connected at 26400 bps
58 CONNECT 28800 *
Connected at 28800 bps
59 CONNECT 31200 *
Connected at 31200 bps
60 CONNECT 33600 *
Connected at 33600 bps
70 CONNECT 32000 *
Connected at 32000 bps, 56K rate
71 CONNECT 34000 *
Connected at 34000 bps, 56K rate
72 CONNECT 36000 *
Connected at 36000 bps, 56K rate
73 CONNECT 38000 *
Connected at 38000 bps, 56K rate
74 CONNECT 40000 *
Connected at 40000 bps, 56K rate
75 CONNECT 42000 *
Connected at 42000 bps, 56K rate
76 CONNECT 44000 *
Connected at 44000 bps, 56K rate
77 CONNECT 46000 *
Connected at 46000 bps, 56K rate
78 CONNECT 48000 *
Connected at 48000 bps, 56K rate
79 CONNECT 50000 *
Connected at 50000 bps, 56K rate
80 CONNECT 52000 *
Connected at 52000 bps, 56K rate
81 CONNECT 54000 *
Connected at 54000 bps, 56K rate
82 CONNECT 56000 *
Connected at 56000 bps, 56K rate
88 DELAYED
Delay is in effect for the dialed number
89 BLACKLISTED
Dialed number is blacklisted
*
W
hen the extended result code configuration option is enabled, one of the following codes is append-
ed to the result code, depending on the type of error control connection:
V42bis
– V.42 error control (LAP-M) and V.42bis data compression
V42
– V.42 error control (LAP-M) only
MNP5
– MNP 4 error control and MNP 5 data compression
MNP4
– MNP 4 error control only
NoEC
– No error control protocol