Filter
Top Products
CommPlete 4000 Communications Server User Guide 15
Chapter 3 - Getting Started with RASExpress
iii. Select ISI Setup.
iv. Delete all ISI cards before saving and rebooting the server.
These steps correct the initial subnet error the next time the server loads.
If you set the Remote Client IP Address to any of these values (Use DHCP, or Use
Address Pool, Use Radius), go to step A15. If you selected Use Address Pool, you
must configure the address pool. See the RAS
Express
User Guide.
A15. When the above steps are complete, press Esc and save the changes to disk. You will be
asked to re-boot the server.
A16. Type Y and press Enter. The connection closes while the RAS
Express
server re-boots. A
new menu appears after the CommPlete 4000 has re-booted.
A17. To complete the configuration of the RASExpress server, select Configuration of server
from the main menu. For detailed information about the menu options, see Chapter 3 of the
RAS
Express
manual.