Multi-Tech Systems MT5634ZPX Network Card User Manual


 
Multi-Tech Systems, Inc. MT5634ZPX User Guide 13
Chapter - 2 Hardware Installation
Safety Warnings
Never install telephone wiring during a lighting storm.
Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
This product is to be used with UL and cUL listed computers.
Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Avoid using a telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electrical shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
To reduce the risk of fire, use only No. 26 AWG or larger Telecommunication line
cord.
Installation Overview
The MT5634ZPX board contains a four-position DIP switch for COM port assignment and
nine Berg jumpers for setting the IRQ address. The DIP switches and jumpers are
located in the upper left corner of the PC board as shown below. The factory default for
this board is Plug-N-Play (automatic COM port and IRQ address assignment).
MT5634ZPX DIP Switches and Jumpers
Installing the MultiModemZPX consists of six steps:
1. Configuring the modem’s DIP Switch and Jumper settings.
2. Installing the modem in the computer.
3. Connecting the modem to the telephone line and, optionally to an external speaker
and microphone.
4. Installing the modem’s software drivers.
5. Configuring your modem for country-specific operation (if you are using the Global
build of the MT5634ZPX).
6. Configuring your communications software.
Note: unless other wise noted, the pr ocedures which follow apply to both PnP and non-PnP
envir onments.