Multi-Tech Systems MT5634ZPX Network Card User Manual


 
Chapter 4 - Using Your Modem
Multi-Tech Systems, Inc. MT5634ZPX User Guide 26
4. The new password is saved automatically. You now can enter more AT commands or
exit the data communications program. The next time you remotely configure the
modem you must use the new setup password.
Changing the Remote Escape Character
To increase security, you can change a remote modem’s remote configuration escape
character. The remote configuration escape character is stored in register
S9
. The factory
default is 37, which is the ASCII code for the percent character (%). For more information
on ASCII codes, refer to Appendix D.
1. Establish a remote configuration link with the remote modem as described in
Basic
Procedure
on the previous page.
2. Type ATS9=
n
, where
n
is the ASCII code for the new remote configuration escape
character. Then press ENTER.
Caution: Setting
S9
to 0 (zero) disables remote configuration entirely—if you disable
remote configuration you will no longer be able to configure this device from a remote
location!
3. To save the new value, type AT&W and press Enter.
4. Type ATO, then Enter to exit remote configuration.