Multi-Tech Systems MT5634ZPX Network Card User Manual


 
Chapter 3 - Driver Installation
Multi-Tech Systems, Inc. MT5634ZPX User Guide 19
Step 4 - Install the Modem Driver
If you use Windows 95/98/Me/2000, you must install the modem driver, which is installed
using the Windows Plug and Play feature. Note, however, that if you use Windows NT
4.0, the modem driver must be installed manually. If you use Windows NT 4.0 or another
operating system, see instructions in Chapter 2 for manual settings. Follow the four-step
procedure below for installing the driver using Windows Plug and Play:
1. Make sure your modem is connected properly, and then turn on your computer.
Windows should detect your new modem and open the Install New Modem wizard.
Note: If Windows cannot find a modem, your modem may be turned off, it may be
plugged into the wrong connector on your computer, or the serial cable may be
faulty. See “Solving Problems” in the
User Guide.
2. Insert the CD into your CD-ROM drive, and then click OK.
3. Windows installs the modem driver. Just follow the steps as you go through the
driver installation Wizard.
4. Click Finish to exit.
Removing a Previous Modem from Your PC
This example uses Windows 2000
1. To remove a modem adapter from Windows 2000, click Start | Settings | Control
Panel. Double click Add/Remove Hardware.
2. The Add/Remove Hardware Wizard displays. Click Next>.
3. When the Choose Hardware Task dialog box displays, select Uninstall/Unplug a
device.
4. Next, in the Choose a Removal Task dialog box, select Uninstall a device, then
click Next>.
5. The Installed devices on your computer dialog box provides a list of devices
installed on your computer. Select the device you want to uninstall from the list.
Click Next>.
6. In the Uninstall a Device dialog box, verify the correct device is highlighted and
select Yes. Click Next> to continue.
7. The Completing the Add/Remove Hardware Wizard indicates Windows has
successfully uninstalled the device. Click Finish to complete the removal of the
device.
Note: If you are removing a Plug and Play device from Windows, you must physically
remove the device from the computer or Windows will request driver installation each
time the system starts.