Filter
Top Products
English
11. REFERENCE
119
11. REFERENCE
11-1. Attaching an Arm Stand
The 630LT-GR can be used with an arm stand by removing the tilt stand and attaching
the arm stand to the terminal.
NOTE
• Use an arm stand that satisfies the following.
- When using the 630LT-GR with an arm stand, the arm stand must be VESA
approved :
Use an arm stand with a 75 mm x 75 mm hole spacing on the arm mounting pad.
Use an arm stand that is able to support an object weighing 8.0 kg.
A GS approved arm stand.
- Use an arm stand with sufficient stability (mechanical firmness) to support the
weight of the monitor.
- Use an arm stand remaining that position where it is manually moved.
- Use an arm stand with the ability to tilt the monitor forward and backward.
• Please connect cables after attaching an arm stand.
Setup Procedure
1. Lay the 630LT-GR down as shown below. Do not scratch the panel.
2. Remove the stand by loosening the screws (M4 x 16 mm).