Filter
Top Products
Index
© National Instruments Corporation I-5 SCXI-1141/1142/1143 User Manual
removing
modules from MAX, B-1
SCXI-1141/1142/1143 from SCXI
chassis, B-1
requirements for getting started, 1-2
ripple, real filters, 4-6
RTD
measurement properties (table), 5-6
S
safety specifications, A-6
SCAN CLK signal
digital I/O connections, 2-12
SCXI chassis
installing the SCXI-1141/1142/1143
module, 1-4
SCXI-1141/1142/1143
calibration, 5-13
common software settings, 3-1
configuration settings, 3-1
dimensions (figure), A-5
documentation, 1-2
hardware, 1-2
measurements, 3-3
software, 1-2
using
LabWindows/CVI to create
code, 5-11
Measurement Studio to create
code, 5-11
SCXI-1141/1142/1143 modules
See also configuration, installation
block diagram, 4-2
overview, 1-1
requirements for getting started, 1-2
SCXI-1141/1142/1143 software installation,
verifying, 1-5
SCXI-1304 or SCXI-1305 terminal block
(note), 2-4
SCXIbus communication signals
emulation by digital I/O signal lines, 2-11
SCXIbus to SCXI-1141/1142/1143 pin
equivalencies (table), 2-12
self-test verification, troubleshooting, 1-5
SER CLK signal
digital I/O connections, 2-11
SER DAT IN signal
digital I/O connections, 2-11
SER DAT OUT signal
digital I/O connections, 2-12
setting cutoff frequency for lowpass filters. See
cutoff frequency for lowpass filters
signal connections
exceeding maximum ratings
(caution), 2-1
front connector
analog input channels, 2-3
digital input and output, 2-6
signal descriptions (table), 2-3
front signal connector
pin assignments (table), 2-2
rear signal connector
analog output signal
connections, 2-11
digital I/O signal connections, 2-11
signals
verifying, 3-4
NI-DAQmx, 3-4
SLOT 0 SEL* signal
digital I/O connections, 2-11
software
installation, SCXI-1141/1142/1143,
verifying, 1-5
LabVIEW, 1-2
LabWindows/CVI, 1-2
Measurement Studio, 1-2
NI-DAQ, 1-2
SCXI-1141/1142/1143, 1-2