NEC lcd projector Projector User Manual


 
8
1. Introduction
Terminal Panel Features
1. COMPUTER 1 IN/Component Connector (Mini
D-Sub 15 Pin) (
page
14, 16)
AUDIO IN (Stereo Mini Jack) (
page
14, 15, 17)
2. COMPUTER 2 IN/Component (R/Cr, G/Y, B/Cb, H,
V) Connectors (BNC × 5) (
page 14)
AUDIO IN (Stereo Mini Jack) (
page
14)
3. COMPUTER 3 (DVI-D) IN Connector (24 Pin)
(HDCP compatible) (
page 15)
AUDIO IN (Stereo Mini Jack) (
page 15)
4. COMPONENT IN (Y, Cb/Pb, Cr/Pr) Connectors
(RCA) (
page 17)
AUDIO L/MONO, R (RCA) (
page
17)
5. S-VIDEO IN Connector (Mini DIN 4 Pin) (
page
18)
6. VIDEO IN Connector (RCA) (
page
18)
7.
VIDEO/S-VIDEO AUDIO L/MONO, R (RCA) (
page
18)
8. MONITOR OUT Connector (Mini D-Sub 15 Pin)
(
page
16)
9. AUDIO OUT (Stereo Mini Jack) (
page
16)
10.
PC CONTROL Port (D-Sub 9 Pin) (
page 158, 159)
Use this port to connect your PC or control system
to control your projector via a serial cable. This
enables you to control the projector using serial
communication protocol. A commercially available
RS232C cross cable is required to use this port. You
can also control the projector by using PC Control
Utility 3.0 contained on the supplied User Support-
ware 6 CD-ROM. To do so you must first have PC
Control Utility 3.0 installed on your PC. If you are
writing your own program, typical PC control codes
are on page 158.
11. Remote Jack (Stereo Mini Jack) (
page
11)
NOTE:
Connecting the remote cable to the REMOTE mini jack
on the terminal panel will make the wireless operation
unavailable.
12. USB Port (Type A) (
page 3
7)
13. LAN Port (RJ-45) (
page
19, 110)
14. USB Wireless LAN unit (
page
160)
NOTE: A dummy cover is provided on this location of the
projector which does not come standard with the USB
Wireless LAN Unit.
The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not af-
fect the projector’s performance.
WIRELESS
USB(LAN)
WIRELESS
14
7 8 1011
134 12 3 2
165 9