Filter
Top Products
93
2-6. Controller Configuration
If you press [4] on the Main Menu, the screen shown below appears.
This screen allows you to set the boot procedure at detection of an error and also see the
system resources.
FastBuild (tm) Utility (c) xxxx-xxxx Promise Technology, Inc.
Halt On Error : Disable
[ Adapter Configuration - Options ]
[←,,Space] Change Option [ESC] Exit
[ Keys Available ]
Installed Memory Address : DEDF8000 Size : 64M
Controller IRQ : 10
ATA IO Address : D800
XOR and HDMA IO Address : D400
Sequence Control IO Address : D000
Flash and SRAM Memory Address : DEE00000
[ System Resources Configuration ]
[Halt On Error]
Allows you to set the boot procedure at detection of an error during POST.
Halt On Error Operation at start
Disable (recommended)
Disconnect the defected HDD and boot the system in the
critical state.
Enable
Halt the boot process. To continue the boot process, press
the [Esc] key manually.
Halt On Error setting procedure:
1. Press the [4] key on the Main Menu to activate [Controller Configuration]
2. Put the cursor on the setting value and press the [Space] key or the arrow key
[←].
3. After changing the setting, press [Esc] to return to the Main Menu.
Notice
If you turn off the power of the server without returning to the Main Menu or
press [Ctrl] + [Alt] + [Del] to reboot the server after changing the setting, the
changing is cancelled.