Filter
Top Products
63
5-3. Installing the Disk Array Controller
1. Confirm the position of the PCI slot in which the disk array controller is installed
and remove the corresponding additional slot cover.
Notice
Save the removed additional slot cover carefully. The removed screw will
be used to install the card. Do not lose them.
The card does not support the PCI hot-plug feature. Before install or
remove the card from the server, always turn off the server and pull out
the power cord from the receptacle.
Check
Some limitation may be imposed to the installation on the PCI slot
depending on the type of the server. Before the installation, check the
limitation following the User’s Guide of the server.
2. Insert the card into the PCI slot securely and fix it. To fix the card with screws, use
the screw removed when the additional slot cover is removed.
This card (disk array controller)
Screw
3. To connect an additional battery to the card, install the battery in the same
procedure.
Notice
When the card cannot be inserted into the PCI slot well, pull out it once
and insert it again. Note that the cared may be damaged if excess force
is given to it.
For details of how to install the additional battery, refer to the User’s
Guide of the N8103-93 Battery Backup Unit (SATA).