Filter
Top Products
61
5-1. Prepare for setup
Notice
Note the following before the setup.
Only a single disk array controller can be installed in a server.
Some limitation may be imposed to the installation on the PCI slot
depending on the type of the server. Before the installation, check the
limitation following the User’s Guide of the server.
HDDs to be connected to the card should have the same specification.
Contact your service representative for HDDs which can be connected to
the card.
The card may coexist with other PCI boards (including disk array
controller, mirroring board, and SCSI controller) only limitedly. Before
using the card together with other PCI boards, ask your service
representative whether the card can coexist with the other PCI boards.
1. Exit from all applications and shut down OS.
2. Press the POWER switch on the server to turn off the power of the server.
3. Pull out all the power cords connected to the power unit of the server from the
receptacles.
4. Remove the side cover on the server following the procedure described in the
User’s Guide of the server.
Check
For the installation or removal of the side cover and other components on
the server, refer to the User’s Guide of the server.