Filter
Top Products
2-12
Getting Started
This equipment uses an ungrounded power cable. Replace the
cord if it becomes damaged. U.S. and Canadian replacement cords must be UL-
approved (CSA certified in Canada) type SPT-2, 18 AWG, 2-conductor cord with a
permanently attached NEMA type 5-15P plug at one end, and a permanently attached
connector body on the other. Cord length may not exceed 15 feet.
Outside the U.S. and Canada the cord must be rated for at least 250VAC at 10 amps,
and must indicate international safety agency approval. The plug must be a type
appropriate for the country where it is used. Check with your local dealer for HAR type
18 AWG, 2 conductor cord, or better. (Reference the booklet, “Getting Service and
Support for Asia, Australia, and Europe” to find out how to contact the local office in your
country.)
Obtain replacement cords at an authorized service center. The replacement must be of
the same type and voltage rating as the original cord.
Disconnect all supply lines before the hinged front cover is removed. Replace the
hinged cover before the unit is restarted.
System Care
The NEC Versa VX is a durable, dependable system built for extensive use and travel.
Follow these guidelines to maintain the condition, performance and safety of your
computer. Please read these safety instructions carefully and keep this user’s guide for
reference.
Immediately turn off and unplug the NEC Versa VX under the
following conditions:
!
The power cord is damaged or frayed.
!
Liquid spills on or into the NEC Versa VX.
!
System is dropped or casing is damaged.
Precautions
Follow these precautions when using your NEC Versa VX and AC adapter. Always
follow all cautions and warnings.
!
Avoid dropping or bumping the computer or the AC adapter.
!
Do not stack heavy objects on the computer, the AC adapter, or the battery packs.
!
Do not place items near the NEC Versa VX that could block air vents and cause
overheating.