Filter
Top Products
June 2004 NEC Business Solutions Ltd
44 - Chapter 4 Backing Up & Restoring the System
Doc. No. 8557 - Release 1.1
June 2004
To install network protocols for backups, continued
1 At the OS/2 command prompt, type f: and press ENTER.
2Type cd \ and press ENTER.
3Type setup and press ENTER.
4Type y to proceed with the voice messaging system Setup utility.
5 From the Setup Type menu, type 2 to choose “Configure System” and
press ENTER.
6 Follow the on-screen instructions until you reach the Update
Configuration menu.
7 Choose “Configure Network Protocols (for Network Backup/Restore)” by
typing the corresponding menu number and pressing ENTER.
8 When you have completed your selection, press ENTER to continue.
9 From the Select Network Protocols
menu, select all that apply:
• To select IPX/SPX, type 1 and press ENTER.
• To select TCP/IP, type
2 and press ENTER.
• To select NetBIOS over TCP/IP, type
3 and press ENTER.
NOTE:
To set up NetBIOS over TCP/IP, a TCP/IP configuration is also
required. Select option 2 and 3 to set this up.
10 When you have completed your selection(s), press ENTER.
11 If you selected TCP/IP, perform the following actions. Otherwise, go to
step 13.
• Type 1 and press ENTER. Type the correct value for the “TCP/IP Address”
field and press ENTER.
• Type
2 and press ENTER. Type the correct value for the “Subnet Mask”
field and press ENTER.
• Type
3 and press ENTER. Type the correct value for the “Default Router”
field and press ENTER.
• Type
4 and press ENTER. Type the correct value for the “Domain” field and
press ENTER.
• Type
5 and press ENTER. Type the correct value for the “Name Server”
field and press ENTER.
12 Confirm your entries are correct. Press ENTER to continue.
13 If you selected IPX/SPX, perform the appropriate action below.
Otherwise, go to step 2.
• To select “Version 3.x or 4.x bindery mode,” type 1 and press ENTER.
• To select “Version 4.x directory service,” type
2 and press ENTER.
14 If you selected “Version 3.x or 4.x bindery mode,” perform the following
actions. Otherwise, go to step 15.
• Type m and press ENTER. Type the correct value for the “NetWare name
context” field and press ENTER.
• Confirm your entry is correct. Press ENTER to continue.