Filter
Top Products
47
■ Registry Edit
This feature allows you to change various parameters of the
source on the selected line. This can be done to the current
projected signal as well as not projected source.
To edit the registered signal, proceed as follows:
1) Press the ADJUST button.
• The Adjust menu is displayed.
2) Use the CURSOR or button to highlight the “1.Source
Registry” line and press ENTER.
• The Source Registry menu will be displayed.
• You can also select the Source Registry menu directly by
pressing the INPUT “1” button.
Items to select
• New Entry------------ Registers a new signal.
• Registry Edit--------- Changes setting various parameters
of the registered signals.
3) Use the CURSOR or button to highlight the “2. Registry
Edit” line and press ENTER.
• The “Registry Edit” screen is displayed.
4) Use the CURSOR or button to highlight the registered
signal and press ENTER.
• The “Edit Command” menu is displayed. Then proceed as
follows:
* Cut Enables you to remove a selected signal from the list
and place it on the “clipboard” in the projector.
* Copy Enables you to copy a selected signal from the list and
place it on the “clipboard” in the projector.
* Paste Enables you to paste the signal placed on the “clip-
board” to any other line of the list. To do this, select “Paste”
and then select the line number you want to paste to. Last
press ENTER.
* Information Enables you to set a various parameters. When
“Information is selected, the Source Information screen is
displayed. Select an item and press ENTER.
5) When setting is completed, press END.
NOE: The contents will leave the “clipboard” when you press
END.
Edit Command
Cut
Copy
Paste
Information
3.OPERATION