Filter
Top Products
HS1100 Wireless Hotspot Gateway User Manual
28
y LAN1 & LAN2 Port
IP PNP: Choose to enable or disable this function. If “IP PnP” is enabled, no matter what the IP address of the
client device is – static or dynamic IP, users can access the network without changing the client IP address after
being authenticated by HS1100.
User Authentication: Choose to enable or disable this function. If “User Authentication” is disabled, users
can access the Internet without being authenticated.
Operation Mode: Choose one of the two modes, NAT mode and Router mode, by the requirements.
IP Address: Enter the desired IP address for the LAN1 & LAN2 port.
Subnet Mask: Enter the desired subnet mask for the LAN1 & LAN2 port.
y DHCP Server Configuration
There are three methods to set the DHCP Server: Disable DHCP Server, Enable DHCP Server and Enable
DHCP Relay.
1. Disable DHCP Server: Disable DHCP Server function.
2. Enable DHCP Server: Choose “Enable DHCP Sever” function and set the appropriate configuration for
the DHCP server. The fields with red asterisks are required to be filled in.