NetComm HS1100 Network Router User Manual


 
HS1100 Wireless Hotspot Gateway User Manual
37
o Super G: Choose Enable or Disable this function.
o Short Preamble: Choose Enable or Disable this function.
o Transmit Power: The default value is Auto. Select a range of transmission speeds or use the
default setting, Auto, to allow the access point to automatically use the fastest possible data rate.
o Beacon Interval: The default value is 100 milliseconds. The specified value represents the
amount of time between access point beacon signal transmissions.
o RTS Threshold: Ready To Send threshold. The range is from 256 to 2346 and the default is OFF.
The administrator can set the value which is the amount of time between packet transmissions. It is
recommended that the value remains in the range of 256 to 2346.
o Fragment Threshold: The range is from 256 to 2346 and the default is OFF. The value specifies
the maximum size of a packet allowed before data is fragmented into multiple packets. It should be
remained in the range of 256 to 2346. A smaller value results in smaller packets but allows a larger
number of packets in transmission.
o Broadcast SSID: Enable or disable SSID broadcast. When disabled, clients cannot detect Access
Point by its SSID broadcast, they must manually connect to Access Point by entering SSID on their
devices.
o Station Isolation: When enabled, wireless client stations are isolated from each other. In other
words, one PC on the wireless network is not able to see other PCs on the same wireless network.
o WMM: WMM (Wi-Fi Multimedia) provides basic Quality of service (QoS) features to Wi-Fi networks.
When enabled, it prioritizes traffic according to four Access Categories (AC) - voice, video, best
effort, and background. However, it does not provide guaranteed throughput.
o IAPP: IAPP (Inter-Access Point Protocol) is to support smooth users’ hand-over (roaming) from
one access point to another. When enabled, it provides a better capability for wireless client
stations to roam among APs with the same SSID.