Filter
Top Products
8 NP2624M User Guide
YML827 Rev1
1.3.3 Telnet management
In addition to local terminal mode operation, the NP2624M switch supports remote management
through Telnet over a network or the internet without a web browser. In this mode, the user has to
enter the same settings as required in in-band management to the IP Configuration before executing
the Telnet program. Again, after properly setting the switch, save the settings and connect your
Ethernet cable from your PC to any port of the Switch. Then you simply type the following at the
command line to access the switch:
Telnet IP_Address_of_Switch
The following window appears. Follow the prompts and type in the “username” and “password” to
proceed. Refer to the instructions in chapter 3 of this manual for more information.