Filter
Top Products
GS700TR Smart Switch Software Administration Manual
4-2 Configuring Routing
v1.0, May, 2008
To access the IP Configuration page:
1. Click Routing > IP > IP Configuration in the navigation tree.
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
3. If you make any changes to the page, click Apply to apply the changes to the system.
VLAN Routing Wizard
Use the VLAN Routing Wizard page to configure VLAN Routing interfaces on the system. ]
To access the VLAN Routing Wizard page:
1. Click Routing > IP > Routing Wizard in the navigation tree.
Figure 4-1
Table 4-1. IP Configuration Fields
Field Description
Default Time to Live The default value inserted into the Time-To-Live field of the IP header of
datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol.
Routing Mode Select either the Enable or the Disable radio button. You must enable
routing for the switch before you can route through any of the
interfaces. Routing is also enabled or disabled per VLAN interface. The
default value is Disable.
Maximum Next Hops The maximum number of hops supported by the switch. This is a read-
only value.