Filter
Top Products
GS700TR Smart Switch Software Administration Manual
1-4 Getting Started
v1.0, May, 2008
Use your web browser to manage your switch. The default password is password. Then use
this page to proceed to management of the switch covered in
“Using the Web Interface” on
page 1-9.
SmartWizard Discovery in a Network without a DHCP Server
This section describes how to set up your switch in a network without a DHCP server, and is
divided into the following tasks:
• “Manually Assigning Network Parameters” on page 1-4
• “NIC Setting on the Host that Accesses the GS700TR Gigabit Smart Switch” on page 1-5
Manually Assigning Network Parameters
If your network has no DHCP service, you must assign a static IP address to your switch. If you
choose, you can assign it a static IP address, even if your network has DHCP service.
To assign a static IP address:
1. Connect the GS700TR Gigabit Smart Switch to your existing network.
2. Power on the switch by plugging in the AC-DC power adapter. (Default IP is 192.168.0.239),
3. Install the SmartWizard Discovery utility on your computer.
Figure 1-2