Filter
Top Products
GS700TR Smart Switch Software Administration Manual
Getting Started 1-15
v1.0, May, 2008
To use SNMPv3 Authentication for this user, set a password of eight or more alphanumeric
characters.
3. To enable authentication, use the Authentication Protocol menu to select either MD5 or SHA
for the authentication protocol.
4. To enable encryption, use the Encryption Protocol menu to select DES for the encryption
scheme. Then, enter an encryption code of eight or more alphanumeric characters in the
Encryption Key field.
5. Click Apply.
To access configuration information for SNMPv1 or SNMPv2, click System > SNMP >
SNMPv1/v2 and click the page that contains the information to configure.
Common Parameter Values
Parameter values might be names (strings) or numbers.To use spaces as part of a name parameter,
enclose the name value in double quotes. For example, the expression “System Name with
Spaces” forces the system to accept the spaces. Empty strings (““) are not valid user-defined
strings.
Table 1-3 describes common parameter values and value formatting.
Interface Naming Convention
GS700TR Smart Switch Switch supports physical and logical interfaces. Interfaces are identified
by their type and the interface number. The physical ports are gigabit interfaces and are numbered
on the front panel. You configure the logical interfaces by using the software. The following table
describes the naming convention for all interfaces available on the switch.
Table 1-3. Parameter Descriptions
Parameter Description
ipaddr This parameter is a valid IP address. You can enter the IP address in the
following formats:
a.b.c.d (8.8.8.8)
Interface g1, g2, etc. for the physical interfaces.
Logical Interface Represents a logical interface. This is applicable for a LAG (port-channel)
interface which is represented as l1, l2...., and applicable for a VLAN routing
interface represented as r1, r2....