Filter
Top Products
GS700TR Smart Switch Software Administration Manual
Getting Started 1-5
v1.0, May, 2008
4. Start the SmartWizard Discovery utility.
5. Click Discover for the SmartWizard Discovery utility to find your GS700TR Gigabit Smart
Switch. You should see a screen similar to
Figure 1-1 on page 1-3.
6. Click Configuration Setting. A screen similar to Figure 1-3 appears.
7. Choose the Disable radio box to disable DHCP.
8. Enter your chosen switch IP address, gateway IP address and subnet mask, and then type your
password and click Set.
Please ensure that your PC and the GS700TR Gigabit Smart Switch are in the same subnet. Make
a note of these settings for later use.
NIC Setting on the Host that Accesses the GS700TR Gigabit
Smart Switch
The settings of your network interface card (NIC) under the MS Windows OS are made with
entries into Windows screen pages similar to the ones shown in
Figure 1-4. For comparison, refer
to the settings pages of the switch shown in Figure 1-1 on page 1-3 and in Figure 1-3 on page 1-5,
although they do not appear in the Windows view. You need Windows Administrator privileges to
change these settings.
Figure 1-3