genie ADVANCED Home
47
JNR1010v2 N150 Wireless Router
Note: If you change the LAN IP address of the router while connected
through the browser, you are disconnected. If this situation occurs,
you must open a new connection to the new IP address and log in
again.
To change the LAN settings:
1. Log in to the router.
For more information, see Log In to Your Router After Installation on page 18.
2. Select ADV
ANCED > Setup > LAN Setup.
The following screen displays:
3. Enter the following settings:
• IP Address.
The LAN IP address of the router (by default, 192.168.1.1).
• IP Subnet Mask.
The LAN subnet mask of the router (by default, 255.255.255.0).
Combined with the IP address, the IP subnet mask allows a device to know which
other addresses are local to it, and which must be reached through a gateway or
router.
• RIP Direction. Router Information Protocol (RIP) enables a router to exchange
routing information with other routers.
This setting controls how the router sends and