Filter
Top Products
M1112 Administrator Manual
E Copyright Nokia Networks Oy
C33907001SE_00
2-12
function classifies IP traffic flows based on IP address, protocol and
port fields. It is capable of identifying the IP flow from all supported
payload encapsulation formats. WFQ works properly only with
IP-based protocols. If the flow is IP-based but is encrypted using IPSec
or PPP encryption, then WFQ cannot identify the flows correctly. In
this case, the default flow is used and the default flow is treated as a
single flow.
2.2.11 Management
There are three management methods in M1112:
D Command line interface (CLI) through console serial port
D CLI via telnet
D Web browser management
The CLI allows complete configuration of the unit; the Web browser
management allows the configuration of the most frequently used
configuration parameters.
2.2.12 Dedicated management channel
The operator or the Internet Service Provider can establish a dedicated
management channel to M1112. This channel provides access to the
M1112 management (with telnet or web browser) and it can be used to
upload a new software to M1112.
The dedicated management channel is separated from the other IP
stack. It is not possible to access the other interfaces or networks
behind the data interfaces through the dedicated management channel.
Similarly, access from LAN or data VCCs to the management channel
is blocked. The management channel supports only routing using the
following encapsulations:
D RFC2684 LLC encapsulation for bridged IP (ETH-LLC)
D RFC2684 LLC encapsulation for routed IP (IP-LLC)
D RFC2364 Virtual circuit multiplexed PPP over AAL5 (PPP-VC)
In Figure, 2-6 VCC1 is used for customers data transmission.
Administration through this channel has been disabled. The operator
or the service provider uses the management VCC for management
purposes only.