Filter
Top Products
Managing M1112
E Copyright Nokia Networks Oy
C33907001SE_00
5-21
Setting Value
Speed 9600
Parity None
Data bits 8
Stop bits 1
Duplex Full
Flow control None
Table 5-1 Local management console configuration
Use the 10Base-T Ethernet cable with the serial adapter to connect you
PC’s serial port to the local management console interface according to
Figure 5-12.
serial adapter
10Base-T
Ethernet cable
Figure 5-12 Local management cabling
The command line interface can also be accessed through the Ethernet
port of M1112 or through the ATM channels of M1112 on top of the
telnet protocol. In order to use the CLI through telnet or the ATM
channel, the IP function must be switched on and IP address must be
given to the corresponding interface.
M1112 can also be managed remotely through a separate ATM virtual
channel. This channel is only used for management purposes. In order
to use this management channel, it has to be activated first and given an
IP address configuration. The management traffic to this interface is
not routed to any other interfaces of M1112.