Filter
Top Products
Installing Nokia M1112
E Copyright Nokia Networks Oy
C33907001SE_00
4-3
4.2 Step-by-step installation procedure
1. Plug the mains power cord to a mains outlet.
2. Switch on M1112. The PWR indicator lights up.
3. Connect the 8-pin Ethernet cable between your PC’s 10 Base-T
Ethernet card and the Ethernet connector on the M1112 back
panel.
4. Switch on your PC. The indicator corresponding the Ethernet port
you connected your PC to becomes green when your PC has
started. This indicator blinks when there is traffic in the
corresponding Ethernet port.
5. Connect the 6-pin ADSL line cable between the ADSL connector
on the M1112 back panel and your ADSL line wall socket. If you
want to use ISDN and ADSL data services simultaneously,
connect a splitter according to Figure 4-1. After a while, the DSL
indicator starts blinking indicating that the ADSL connection is
being established. After the connection has been established
successfully the DSL indicator remains lit.
6. During normal operation PWR and DSL indicators are lit and the
Ethernet indicators of the active Ethernet ports blink or are lit
depending whether there is traffic or not. COL indicator may blink
occasionally during normal operation.
splitter
ISDN NT1
U int.
S int.
Figure 4-1 M1112 and splitter connected
Now, your M1112 has been connected and you can check the
connections according to your service provider’s instructions. See