Filter
Top Products
M1112 Administrator Manual
E Copyright Nokia Networks Oy
C33907001SE_00
3-2
3.1.1 Ethernet interface
The Ethernet interface (ETH) is located on the back panel. The
Ethernet interface is a standard 10 Mbit/s half-duplex 10Base-T
interface. The mechanical connector is an 8-pin RJ-45. The pin-out
numbering is shown in Table 3-1.
18
Figure 3-2 ETH connector
PIN Signal Direction
M1112-
Ethernet
MDI signal
1 Rx+ <– Receive data +
2 Rx– <– Receive data –
3 Tx+ –> Transmit data +
6 Tx– –> Transmit data –
Table 3-1 Ethernet interface pin-out numbering
3.1.2 ADSL interface
The ADSL interface (DSL) is compatible with ETSI TS 101 388
specification. The mechanical connector is a 6-pin RJ-11. The pin-out
numbering is shown in Table 3-2.
16
Figure 3-3 DSL connector