Filter
Top Products
M1112 Administrator Manual
E Copyright Nokia Networks Oy
C33907001SE_00
5-22
The command line interface has been divided into two modes: main
and configuration. The main mode lets you monitor the status and
performance of M1112. The configuration mode lets you change
M1112 configuration. The CLI is case sensitive. All commands must
be given in lower case characters. Only file names and strings can
contain upper case characters.
In the configuration mode, functions can be activated by typing the
corresponding command, for example
bridging. The function can be
deactivated by simply typing no bridging. In commands which
require typing in parameter values, the default value can be restored by
typing
de ppp mru, for example. de in front of the command means
“default”. If you type in a value which is incorrect (for example, letters
instead of numbers), the CLI prompts you to enter the value correctly
and displays help. You can always get help on the command or display
by typing
help or ? at the command prompt.
You can recall you previous commands by pressing the “up-arrow”
key on your keyboard.
The configuration mode has been divided into levels. You can navigate
through the configuration mode by typing the name of the level. By
typing exit you will return to the main mode. top command returns
you to the root level of the configuration mode (M1112(conf)#).
The configuration mode levels are:
D system
D password
D eth
D vcc1, vcc2, vcc3, vcc4, vcc5, vcc6, vcc7, and vcc8
D vbridge
D mngtvcc
D common.
The example below shows how to access the different levels:
M1112>
M1112>conf
M1112(conf)#system
M1112(conf-system)#password
M1112(conf-password)#eth
M1112(conf-eth)#vcc1
M1112(conf-vcc1)#vcc2
M1112(conf-vcc2)#vcc3
M1112(conf-vcc3)#vcc4