Filter
Top Products
288 MG 1000B telephones
Procedure 32
Using the Set-Based Removal feature
Step Action
When the Automatic Set Removal (AREM) feature is enabled and you have
a Set Relocation Security Code (SRCD), follow these steps:
1
Lift the handset or press the DN key of the IP Phone to be removed.
2
Key in the AREM code after hearing the dial tone.
3
Enter the SRCD.
4
Hang up, or press the Release key.
—End—
Analog and digital devices in the Branch Office
Analog devices
Analog (500/2500-type) telephones are supported in the Branch Office, but
are not centrally managed from the main office. Instead, they are managed
at each Branch Office. When a call is between an analog (500/2500-type)
telephone and an IP Phone, a DSP resource is required. Therefore, when
analog (500/2500-type) telephones are located in the Branch Office, allow
for additional voice gateway channels to support IP-TDM connections.
Analog (500/2500-type) telephones at a Branch Office can be configured
using:
•
Set-Based Installation
•
Overlays (locally or remotely through a modem or Ethernet connection).
For more information, see Procedure 27 "Installing IP Phones through
overlays" (page 279).
•
TM 3.01
Analog devices supported by the Branch Office feature include analog
(500/2500-type) telephones, fax machines, and modems.
Digital devices
Digital telephones and attendant consoles are supported in the Branch
Office, but are not centrally managed from the main office. Instead, they
are managed at each Branch Office. When a call is between a digital
telephone and an IP Phone, a DSP resource is required. Therefore, when
digital telephones are located in the Branch Office, allow for additional voice
gateway channels to support IP-TDM connections.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.