Filter
Top Products
309985-B Rev 00
2-1
Chapter 2
Installing the BayStack 410-24T Switch
This chapter covers the following topics:
• Installation requirements
• Installation procedure
• Instructions for connecting power
• Instructions for verifying the installation
• Instructions for the initial (standalone) switch setup
• Instructions for the initial stack setup
Refer to Chapter 3, “Using the Console Interface,” to further configure your
BayStack 410-24T switch.
Installation Requirements
Before installing the BayStack 410-24T switch, verify that the package contains
the following items in addition to this guide (see Figure 2-1
).
Install the BayStack 410-24T switch in a ventilated area that is dust free and away
from heat vents, warm air exhaust from other equipment, and direct sunlight.
Avoid proximity to large electric motors or other electromagnetic equipment.
When choosing a location, observe the environmental guidelines listed in
Appendix A, “Technical Specifications.” You will need a Phillips screwdriver for
the installation.
Note:
Be sure that the supplied AC power cord matches the requirements for
your region; see “AC Power Receptacle” on page 1-7.