Filter
Top Products
Using the BayStack 410-24T 10BASE-T Switch
3-52
309985-B Rev 00
Port Configuration
The Port Configuration screen (Figure 3-21 and Figure 3-22) allows you to
configure specific switch ports or all switch ports. You can enable or disable the
port status of specified switch ports, set (optional) MDA ports to autonegotiate for
the highest available speed of the connected station, and you can set the duplex
mode for specific ports (autonegotiation is not supported on fiber optic ports).
You can disable switch ports that are trunk members; however, the screen prompts
for verification of the request before completing the action. Choosing [Yes]
disables the port and removes it from the trunk.
Choose Port Configuration (or press p) from the Switch Configuration Menu
screen to open the Port Configuration screen.
Figure 3-21. Port Configuration Screen (1 of 2)
Note:
The Autonegotiation fields, the Link Trap, the Speed fields, and the
Duplex fields are independent of MultiLink trunking, rate limiting, VLANs,
IGMP Snooping, and the STP.
Port Configuration
Unit: [ 1 ]
Port Trunk Status Link LnkTrap Autonegotiation Speed Duplex
---- ----- ------------ ----- ------- --------------- -----------------
1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Half ]
2 [ Enabled ] Up [ On ] [ Enabled ] [ 10Mbs / Full ]
3 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Full ]
4 [ Enabled ] Up [ Off ] [ Disabled ] [ 100Mbs / Half ]
5 [ Enabled ] Down [ On ] [ Disabled ] [ 100Mbs / Half ]
6 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
7 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
8 [ Enabled ] Down [ Off ] [ Disabled ] [ 100Mbs / Half ]
9 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
10 [ Enabled ] Down [ On ] [ Disabled ] [ 100Mbs / Half ]
11 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Half ]
12 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Half ]
13 2 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
14 2 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
More...
Press Ctrl-N to display choices for additional ports..
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.