Filter
Top Products
Getting Started with the Contivity Extranet Switch 4500
2-14
Understanding the LEDs
The
Power LED
is green when the power is on; if it is flashing, there is a
hardware failure and you should contact Nortel Networks.
The
Hard Disk LED
is green, and when it flashes the Switch is either reading or
writing to the disk.
The
LAN Port LED
is green, and when it flashes the Switch is either transmitting
or receiving data.
Start the Switch and confirm that the interfaces are cabled properly by examining
the two LEDs located adjacent to the RJ-45 connector of the LAN port, or the
LEDs located on the card panel.
Figure 2-5 shows the private LAN Port LEDs. Look at the condition of the LEDs,
then examine the corresponding LED table to better understand the indications.
Figure 2-5. LAN Port LEDs
Table 2-6. LAN Port LED Indicators
LED Indicator Description
Orange On The cable connections between the LAN port
and the hub are good.
Off The cable connections between the LAN port
and the hub are faulty.
Flashing The LAN port is sending or receiving network
data. The frequency of the flashes increases
with increased traffic.
Green (100) On The LAN port is operating at 100 Mb/s.
Off The LAN port is operating at 10 Mb/s.
Green
Orange