Filter
Top Products
Getting Started with the Contivity Extranet Switch 4500
7-6
Follow these steps to install a DIMM into the Switch.
1.
Remove the stabilization bracket by loosening the two secured captive
screws and the rear Phillips screw.
2.
Turn off the Switch.
3.
Remove the power cords.
4.
Unscrew the sliding tray at the back of the unit and pull it out using the
thumb screws.
5.
Press down the locking levers on both sides of the DIMM.
6.
Pull the DIMM up to remove it from the slot.
7.
Place a new DIMM in the next available slot, making sure to properly
position the DIMM's alignment keys.
8.
Pull up the locking levers on both sides of the DIMM, and snap the
DIMM into its socket.
Memory Options
The Switch ships with 128 Mbits of memory installed. To increase the memory,
contact your Nortel Networks sales representative.