Filter
Top Products
Mediant 2000 SIP
Mediant 2000 SIP User’s Manual 190 Document #: LTRT-72504
• Protection against entering faulty information.
• Remote reset.
• Unicast BootP response.
• User-initiated BootP respond, for remote provisioning over WAN.
• Filtered display of BootP requests.
• Location of other BootP utilities that contain the same MAC entity.
• Common log window for both BootP and TFTP sessions.
• Works with Windows™ 98, Windows™ NT, Windows™ 2000 and Windows™ XP.
B.4 Specifications
• BootP standards: RFC 951 and RFC 1542
• TFTP standards: RFC 1350 and RFC 906
• Operating System: Windows™ 98, Windows™ NT, Windows™ 2000 and Windows™ XP
• Max number of MAC entries: 200
B.5 Installation
To install the BootP/TFTP on your computer, take these 2 steps:
1. Locate the BootP folder on the VoIP gateway supplied CD ROM and open the file Setup.exe.
2. Follow the prompts from the installation wizard to complete the installation.
To open the BootP/TFTP, take these 2 steps:
1. From the Start menu on your computer, navigate to Programs and then click on BootP.
2. The first time that you run the BootP/TFTP, the program prompts you to set the user
preferences. Refer to the Section
B.10 on page 193 for information on setting the
preferences.
B.6 Loading the cmp File, Booting the Device
Once the application is running, and the preferences were set (refer to Section B.10), for each
unit that is to be supported, enter parameters into the tool to set up the network configuration
information and initialization file names. Each unit is identified by a MAC address. For information
on how to configure (add, delete and edit) units, refer to Section
B.11 on page 195.
To load the software and configuration files, take these 4 steps:
1. Create a folder on your computer that contains all software and configuration files that are
needed as part of the TFTP process.
2. Set the BootP and TFTP preferences (refer to Section
B.10).
3. Add client configuration for the VoIP gateway that you want to initialize by the BootP, refer to
Section
B.11.1.
4. Reset the VoIP gateway, either physically or remotely, causing the device to use BootP to
access the network and configuration information.