Filter
Top Products
Mediant 2000 SIP User’s Manual 3. Installing the Mediant 2000
Version 4.4 27 July 2005
3 Installing the Mediant 2000
This section describes the hardware installation procedures for the Mediant 2000. For information
on how to start using the gateway, refer to Section
4 on page 35. For detailed information on the
Mediant 2000 connectors, LEDs and buttons, refer to Section
2 on page 19.
Caution Electrical Shock
The equipment must only be installed or serviced by qualified service personnel.
To install the Mediant 2000, take these 4 steps:
1. Unpack the Mediant 2000 (refer to Section 3.1 below).
2. Check the package contents (refer to Section
3.2 below).
3. Mount the Mediant 2000 (refer to Section
3.3 on page 28).
4. Cable the Mediant 2000 (refer to Section
3.4 on page 30).
After powering-up the Mediant 2000, the Ready and LAN LEDs on the front panel turn to green
(after a self-testing period of about 3 minutes). Any malfunction changes the Ready LED to red
(refer to Section
2.3.2 on page 23 for details on the Mediant 2000 LEDs).
When you have completed the above relevant sections you are then ready to start configuring the
gateway (Section
4 on page 35).
3.1 Unpacking
To unpack the Mediant 2000, take these 6 steps:
1. Open the carton and remove packing materials.
2. Remove the Mediant 2000 gateway from the carton.
3. Check that there is no equipment damage.
4. Check, retain and process any documents.
5. Notify AudioCodes or your local supplier of any damage or discrepancies.
6. Retain any diskettes or CDs.
3.2 Package Contents
Ensure that in addition to the Mediant 2000, the package contains:
• For the dual AC power supply version two AC power cables are supplied; for the single AC
power supply version one AC power cable is supplied.
• For the DC power supply version, one connectorized DC power cable (crimp connection
type) and one DC adaptor (screw connection type) connected to the rear panel of the
Mediant 2000 are supplied; use only one type.
• CD (software and documentation).
• Small plastic bag containing (refer to Figure
3-1):
Two brackets and four bracket-to-device screws for 19-inch rack installation option.
Four anti-slide bumpers for desktop / shelf installation option.
• The Mediant 2000 Fast Track Installation Guide.