Filter
Top Products
Mediant 2000 SIP
Mediant 2000 SIP User’s Manual 52 Document #: LTRT-72504
• You can configure the Trunk Group Settings table to determine the method in which new
calls are assigned to channels within the trunk groups (a different method for each trunk
group can be configured). For information on how to enable this option, refer to Section
5.8.7
on page 60. If a Channel Select Mode for a specific trunk group isn’t specified, then the
global ‘Channel Select Mode’ parameter (defined in ‘General Parameters’ screen under
‘Advanced Parameters’) applies.
To configure the IP to Trunk Group Routing table, take these 6 steps:
1. Open the ‘IP to Trunk Group Routing’ screen (Protocol Management menu > Routing
Tables submenu > IP to Trunk Group Routing option); the ‘IP to Trunk Group Routing’
table screen is displayed.
Figure
5-6: IP to Trunk Group Routing Table
2. In the ‘IP to Tel Routing Mode’ field, select the IP to Tel routing mode (refer to Table
6-5 on
page 115).
3. In the ‘Routing Index’ drop-down list, select the range of entries that you want to edit (up to
24 entries can be configured).
4. Configure the IP to Trunk Group Routing table according to Table
5-4.
5. Click the Submit button to save your changes.
6. To save the changes so they are available after a power fail, refer to Section
5.12 on page
84.
Table
5-4: IP to Trunk Group Routing Table
Parameter Description
Destination Phone Prefix Each entry in the Destination Phone Prefix fields represents a called
telephone number prefix. The prefix can be 1 to 49 digits long. An asterisk
(*) represents all numbers.
Source Phone Prefix Each entry in the Source Phone Prefix fields represents a calling
telephone number prefix. The prefix can be 1 to 49 digits long. An asterisk
(*) represents all numbers.
Source IP Address Each entry in the Source IP Address fields represents the source IP
address of an IPTel call (obtained from the Contact header in the Invite
message).
Note: The source IP address can include the “x” wildcard to represent
single
digits. For example: 10.8.8.xx represents all the addresses between
10.8.8.10 to 10.8.8.99.