Oki 407II Printer User Manual


 
– 7 –
3-2-4. Connecting Ethernet Cable
When using an Ethernet cable that is 10 m or less,
shielded cable is recommended.
(1) Make sure the printer is turned off.
(2)
Afx the ferrite core onto the ethernet cable as
shown in the illustration below.
(3) Pass the fastener through the ferrite core.
(
4) Loop the fastener around the cable and lock it.
Use scissors to cut off any excess.
(5) Connect the interface cable to the connector on
the rear panel of the printer.
Ferrite core
Ethernet cable
10 cm
(maximum)
Fastener