Filter
Top Products
– 36 –
10-2. Auto Cutter Specications
(1) Cutting frequency Max. 20 cuts per minute
(2) Thickness of paper 0.065 ~ 0.15 mm
10-3. Interface
RS-232C serial interface/Two-way parallel interface (IEEE1284)/USB interface/Ethernet in-
terface/Wireless LAN Interface
10-4. Electrical Characteristics
(1) Input Voltage DC 24 V±10%
(2) Current Consumption (DC 24 V at room temperature)
Standby:
Approx. 0.15 A
ASCII printing: Approx. average 1.8 A
(Approx. 17.5% printing rate)
100% print duty: Approx. peak 11.9 A
(Solid printing): Approx. average 5.0 A
(Continuous solid printing should be 10 seconds or less.)
(
3) Power Connector
Pin No. Function
1 Drive power (24 V)
2 Signal GND
3 N.C.
Shell Frame ground
Note:
• When using a printer power supply other than the optional AC adaptor (PS60A-24A),
be sure that the following cautions are observed.
• Use a power supply of DC 24 V ±10% and more than 2.0 A (5.0 A Load 10 sec. Min)
with LPS output approved by IEC60
950.
• Be careful about installing the printer in an area where there is noise. Take the appropri
-
ate measures to protect against electrostatic AC line noise, etc.
<Viewed from Connector Surface>