Filter
Top Products
– 16 –
Notes on Using the Auto Cutter
1) To print after a cut, feed 1 mm (8-dot line) or more of paper.
2) If the cutter is not in its home position after an error, rst eliminate the cause of the error;
then, turn the power back ON.
3) If the printer is placed horizontally, the use of the partial cut is recommended. If you use
the full cut, the cut pieces of paper may fall into the paper outlet passage, causing a paper
jam as a result of cutting multiple pieces of paper. Therefore, do not use the full cut if the
printer is placed horizontally.
4) If you use the full cut, make sure to remove the piece of paper after each cut.
5)
Do not attempt to remove the paper during a cut, as this can cause a paper jam.