Filter
Top Products
– 48 –
■ Initializing Settings
Set the push switch as described below to initialize the
setting information.
Push the switch for one to ve seconds while running
under normal operating mode. The green and red LEDs
will ash with a regular pattern. After that, push the
switch once again in that state to turn OFF both of the
red and green LEDs. This will return the settings of
the interface board to their default, or ex-factory, set-
tings. After the interface board has been initialized, the
printer will automatically reboot itself.
■ LED Display
Green : Lights when other party connection is
recognized as
100BASE-TX.
Red : Lights when packets are received.
Push Switch
LED
11-5. Wireless LAN Interface Model
ON ON
OFF OFF
DIP-SW 1
Switch Function ON OFF
1-1
Command emulation (Ster Line mode) Always ON
1-2
Should not be changed (Should be set to on)
1-3
Should not be changed (Should be set to on)
1-4
Sensor adjustment Invalid Valid
1-5
Should not be changed (Should be set to on)
1-6
Handshaking conditions (conditions for
BUSY)
Ofine or receive
buffer full
Receive buffer full
1-7
Should not be changed (Should be set to on)
1-8
Should not be changed (Should be set to on)
1-9
Low-power consumption mode Invalid Valid
1-10
Should not be changed (Should be set to on)
The factory settings of DIP switch are all on.
No. 1 2 3 4 5 6 7 8 No. 1 2 3 4
9 10
DIP-SW 1 DIP-SW 2