Filter
Top Products
– 45 –
The following is the procedure for changing the settings on DIP switch No. 3.
1. Turn off the printer and all components connected to it.
2. Remove the 2 screws.
3. Remove the serial interface board unit.
4. Change the setting of the DIP switches.
5. Replace the serial interface board unit.
Then secure it with the screws.
6. Turn on the printer and all components connected to it.
The factory settings of DIP switch are all on, except for switches 7 and 8.
DIP-SW
3
Switch Function ON OFF
3-1
Baud Rate See table below
3-2
3-3 Data Length 8 bits 7 bits
3-4
Parity Check Disabled Enabled
3-5
Parity Odd Even
3-6
Handshake DTR/DSR XON/XOFF
3-7
Should not be changed (Should be set to
off)
— —
3-8
Baud Rate Switch 3-1 Switch 3-2
4800BPS
OFF ON
9600BPS
ON ON
19200BPS
ON OFF
38400BPS
OFF OFF
DIP switch 3
No. 1 2 3 4 5 6 7 8
ON
OFF
DIP-SW 3