Filter
Top Products
D - 2
4. DETAIL OF EACH FUNCTION
4.1 Engine Menu Setting
Engine Menu Setting is used to set, display, and change the following menu items: (See Figure
D-1.)
(1) Print Position
Used to adjust the print start position.
(2) LED Head Marking No.
Used to adjust the exposure time of the LED head.
(3) LED Head Width
Used to specify the LED head dot count.
(4) LED Head Wire
Used to specify whether the data wire of the LED head is 300-1W, one-wire (non-adjustment)
type or 300-2W two-wire (adjustment) type. (This printer, however, can use only one-wire
type.) Do not use D600W4.
(5) Setting or Humidity
Used to adjust transfer current.
(6) Head Type
Do not use in this printer.
(7) Wait Table
Do not use in this printer.
(8) Page Prt
Do not use in this printer.
(9) Entry
Used to reflect the engine menu setting values on the printer.
(10)Cancel
Used to clear unreflected items. (Items for which Entry is not specified.)
4.2 Engine Counter
Engine Counter is used to display and initialize the following count values: (See Figure C-1.)