Filter
Top Products
IV - 70
Section 4 - Appendix B - Application Considerations
OKI OkiLAN 6120e User’s Guide
• yourqueuename - This is the name of the queue
on the OkiLAN 6120e and must end with 1, 2, 3
or 4, depending on the port selected to service the
print jobs.
If FF, LF or NF are the last two letters of the
queue name, the job will be converted
accordingly. See the section on Remote Queue
Names.
Prerequisites
Before you proceed, the following prerequisites must
be met. Most of the time steps 2 through 5 are already
configured since the HP-UX system is on a TCP/IP
network. Do not perform steps 2 through 5 unless
the installation procedure fails!
1. The name OKIPRINTER and the IP address
assigned to the OkiLAN 6120e are in the
“/etc/hosts” file on the HP-UX system.
2. Make sure the rlp process is not running by typing at
the UNIX prompt:
ps -e | grep rlp
If rlp is not running, you will not see any output after
executing this command.
If rlp is running (that is, if you see output after
executing this command), kill the process with the
command:
kill -15 process_number.
3. Make sure the following entry is in the
“/etc/inetd.conf” file:
printer stream tcp nowait root “/usr/lib/
rlpdaemon” rlpdaemon -i
If the rlp daemon is not running when a print request
is made, this entry in “/etc/inetd.conf” will tell inetd
to auto-start the rlp daemon and service the pending
print request. This is helpful if the daemon died or
was terminated for some reason. For more
information on inetd or “/etc/inetd.conf”, type man
inetd or man inetd.conf.