Oki 6120E Printer User Manual


 
Hardware Installation
I - 15
Section I - Hardware Installation
OKI OkiLAN 6120e User’s Guide
Solution
a) Unplug the OkiLAN 6120e power adapter from the
wall outlet. Remove the network cable. Plug the
network cable back in until you hear a positive click.
Check the other end of the cable in the same manner.
Plug the OkiLAN 6120e back in. If it does not detect
a cable, continue below.
b) Verify the cable is a 10/100 Base-T cable and it has
an RJ-45 end. The network cable must have a cat-3
or higher rating. Silver Satin or flat ribbon cable is
not adequate.
c) Connect to a network that a currently working PC or
print server is using. If the OkiLAN 6120e is still
unable to detect the network cable, contact Technical
Support for assistance.
Hardware Troubleshooting
Status Indicator
The LED status indicators display the general operating
state of the OkiLAN 6120e. During normal operation,
the red LED is off and the green LED is on, indicating
that the OkiLAN 6120e is functioning properly and the
presence of the network is detected.
The following list describes LED displays that indicate
problems, as well as possible solutions:
LED Display
Green indicator flashing very rapidly
Problem
The OkiLAN 6120e has not detected the presence of a
network cable.